T35 explosion-proof axial exhaust fan has the characteristics of low noise, large air volume, reliable operation, wide range of performance parameters, easy installation, etc., and is widely used in factories and mines workshops and civil and commercial building engineering side wall ventilation. According to the requirements of the conveying medium, it can be made into anti-corrosion and explosion-proof type.

The following is the introduction of T35 explosion-proof axial flow fan:

T35 Explosion-proof axial exhaust fan Overview:

T35(T40)-11 series axial fan is suitable for conveying no corrosion no significant dust gas, the ambient temperature shall not exceed 60℃, widely used in general factories, warehouses, offices, residential ventilation or strong heating heat dissipation, can also have a long exhaust pipe interval series installation to improve the pressure in the pipeline, remove the housing can also be used as a free fan.

T35 explosion-proof axial exhaust fan impeller diameter from small to large a total of 2.8, 3.15, 3.55, 4, 4.5, 5, 5.6, 6.3, 7.1, 8, 9, 10, 11.2 and other 13 specifications, each specification fan blade number is 4, blade Angle 15°, 20°, 25°, 30°, 35° five, wide range of parameters, Air volume 826-67892m3/h, wind pressure 39Pa-474Pa.

T35 Explosion-proof axial exhaust fan Installation instructions:

1. Check whether the fan is damaged and deformed before installation. If it is damaged and deformed, it can be installed only after proper repair.

2, when installing, pay attention to check whether the connecting parts are loose, the gap between the blade and the wind duct should be uniform, and should not collide.

3, the weight of the connecting tuyere pipe should not be borne by the fan duct, and the support frame should be added when installing.

4. The wind collector must be installed at the end of the fan tuyere, and it is hoped that the protective net will be installed.

5, the fan base must be naturally connected with the foundation plane, do not knock the base forced connection, to prevent the deformation of the base, the installation should be corrected, add the iron plate, basically maintain the horizontal position, and then tighten the anchor bolts.

6, after the installation is completed, it must be tested first, and it is allowed to be formally used after normal operation.

T35 Explosion-proof axial exhaust fan Installation instructions:

1. Check whether the fan is damaged and deformed before installation. If it is damaged and deformed, it can be installed only after proper repair.

2, when installing, pay attention to check whether the connecting parts are loose, the gap between the blade and the wind duct should be uniform, and should not collide.

3, the weight of the connecting tuyere pipe should not be borne by the fan duct, and the support frame should be added when installing.

4. The wind collector must be installed at the end of the fan tuyere, and it is hoped that the protective net will be installed.

5, the fan base must be naturally connected with the foundation plane, do not knock the base forced connection, to prevent the deformation of the base, the installation should be corrected, add the iron plate, basically maintain the horizontal position, and then tighten the anchor bolts.

6, after the installation is completed, it must be tested first, and it is allowed to be formally used after normal operation.